If you have not already done so, shut down your server to standby power mode and remove the cover. 2. Check the power supply and backplane board connections. Covered by US Patent. The temperature is far below the thresholds My setup Intel Xeon CPU E3-1230 V2 @ 3.30GHz 2 x Kingston - Minne - 8 GB - DIMM 240-pin - http://centralpedia.com/memory-error/uncorrectable-memory-error-detected-on-processor-1-dimm.html
Why would it still label itself in "Good" status after an uncorrectable memory error? Diagnostics Messages When you run a test group or subtest in the Dell Diagnostics, an error message may result. If the problem still persists, replace the system board. 1-3-3 1-3-4 1-4-1 1-4-2 2-1-1 through 2-4-4 Chip or data line failure in the first 64 KB If the problem still persists, replace the microprocessor. 4-4-4 Cache test failure (defective microprocessor) Remove and reseat the specified microprocessor. original site
Note - The Motherboard Fault LED operates independently of the Press to See Fault button, and does not operate on stored power. No timer tick interrupt Defective system board Replace the system board. Table 1. Back to top #16 Morotalizer Morotalizer HSS Member Members 10 posts Posted 02 September 2014 - 11:23 PM The new MB is now in place and the server has been running
One way would be to take the cover off and put a fan next to it. If the problem persists, replace the DIMMs. The stored power lasts for about half an hour. Uncorrectable Memory Error (system Memory, Memory Module 0) No boot sector on hard-disk drive Incorrect configuration settings in System Setup program, or no operating system on hard-disk drive Verify the hard-disk drive System Setup information is correct.
The thing that's odd is that when I log into HP Management Homepage, the error shows up on the IML but the status of the memory module is still "Good". If the keyboard controller is faulty, replace the system board. 3-3-1 CMOS failure Run the system board test in the Dell Diagnostics to isolate the problem. 3-3-2 System configuration check failure The Integrated Management Log reports Unrecoverable System Error (NMI) has occurred. https://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=254896&docId=emr_na-c02878598&docLocale=en_US Install a correct version of the microprocessor so both microprocessors have the same level 2 cache size.
After the drive is selected for removal, the "drive being prepared for removal" pattern appears, followed by the "drive ready for insertion or removal" pattern. Uncorrectable Memory Error (module Unknown) Install the integrated RAID hardware option if it is available and restart the system. Retain copies of the logs showing the memory errors per the above rules to send to Sun for verification prior to calling Sun. Correctable errors can be detected and corrected if the chipset and DIMM support this functionality.
If a faulty system does not emit beep codes or display system error messages to indicate a failure, you should run the appropriate tests in the Dell Diagnostics to help isolate Solution The issue has been addressed by the UEFI firmware code version 2.12 or later. Uncorrectable Memory Error Hp Join the community of 500,000 technology professionals and ask your questions. Uncorrectable Memory Error Dell All rights reserved.
Article: KTH-PL316E/8G Did the error start the first time you put the new memory in? http://centralpedia.com/memory-error/uncorrectable-memory-error-detected-on-processor.html By default, the Memory Channel Mode is configured to Independent Channel Mode (Non-Lockstep). © Copyright 2016 Hewlett-Packard Development Company, L.P. Please go to HP Support Center. Keyboard data line failure Keyboard stuck key failure Keyboard cable connector loose or improperly connected, defective keyboard, or defective keyboard/mouse controller (defective system board) Check the keyboard cable connection. Corrected Memory Error Threshold Exceeded
The drive activity light may flash briefly. Caution - Before handling components, attach an antistatic wrist strap to a chassis ground (any unpainted metal surface). Sun Fire X4500/X4540 Servers Diagnostics Guide 819-4363-12 Copyright © 2009 Sun Microsystems, Inc. http://centralpedia.com/memory-error/uncorrectable-memory-error-detected-on-processor-1-dimm-3.html Refer to the Sun Integrated Lights Out Manager User's Guide.
Drive being prepared for removal The three drive status indicators flash sequentially. Correctable Memory Error Rate Exceeded For Dimm Provide feedback Please rate the information on this page to help us improve our content. Temperature sensor detected a failure* A temperature probe on the backplane board, system board, or drive carrier in the specified server has exceeded its temperature failure range.
FIGURE 10-1 DIMMs and LEDs on Motherboard Figure Legend 1 DIMMs 0 2 1 3 2 CPU 1 (under heatsink) 3 CPU 0 (under heatsink) 4 DIMMs 3 1 2 0 If booting from a hard-disk drive, replace the hard-disk drive. Good call on replacement. 0 This discussion has been inactive for over a year. In this article, I’ll explain the benefits of employing a hyper-converged system … VMware Virtualization Server Hardware Integrate Cloud Faxing With Your Multifunction Printers and Increase Efficiency From Both Article by:
The system’s printed circuit boards and hard disk drives contain components that are extremely sensitive to static electricity. Look for cracked or broken plastic on the slot. 8. Provide feedback Please rate the information on this page to help us improve our content. http://centralpedia.com/memory-error/uncorrectable-memory-error-detected-on-processor-1-dimm-9.html System Beep Codes Code Cause Corrective Action 1-1-3 CMOS write/read failure Replace the system board. 1-1-4 BIOS checksum failure Reflash the BIOS firmware.
Memory address line failure at address, read value expecting value Memory double word logic failure at address, read value expecting value Memory odd/even logic failure at address, read value expecting value Caution - Use only compressed air to dust DIMMs. 9. Visually inspect the DIMM slot for physical damage. If at first you don't succeed, do it like your mother told you.
The tables in this section list faults that can cause a beep code or system error message to occur and the probable causes of the fault in each case. should I run it with the boot cd or does it suffice to run it from windows? 0 LVL 11 Overall: Level 11 Server Hardware 4 Windows Server 2008 2